GHZP-190.00/4

This photo depicts an hydraulically actuated centring and face clamping device with two swivel clamps. It is combined with a three-jaw chuck for centring. The cassette containing the three-jaw chuck is designed for interchanging in this case and can be replaced by a sliding jaw expansion mandrel. Lubrication of the exchangeable parts is via lubricating nipples.

Type: GHZP, Centre and facing chucks

Item No.: 190.018

Actuation: hydraulic with integrated cylinder

Technical features:

Steel design, all parts hardened and polished
Centring via three-jaw chuck as an interchange part
Face clamping via 2 swivel clamps

Options:

GHA-3B-160.00/1

The GHA-3B-160.00/1 is a compensating three-jaw chuck which centres the work piece with a clamping sleeve...

GHGLP-2B-60.00

The GHGLP-2B-60.00 is a sliding jaw expansion mandrel with 2 jaws. The rectangular sliding jaws are recessed at the clamp point. The clamping range...

GHHY-2B-225.00/2

This hydraulically actuated two-jaw chuck is fitted with a safety function: the work piece is retained via sprung pre-clamping and then end-clamped hydraulically...

GHZP-190.00/4

This photo depicts an hydraulically actuated centring and face clamping device with two swivel clamps. It is combined with a three-jaw chuck for centring...

GHGY-3B-200.00/2/1

This hydraulically actuated three-jaw chuck is fitted with an integrated cylinder for external clamping as well as sword pin for pre-adjustment...

GHZP-170.00/W

This hydraulically actuated centring and face clamping fixture is used for clamping wheel mounts...

GHHY-2B-300.00/9

Two GHHY-2B-300.00/9 two-jaw Hydrozent chucks each, with a size of 300 mm, are used in this clamping device for machining the ends of axles...

GHZP-195.00/1

The challenge for this device was to realise numerous functions with only four connections...